|       | Interrups | Categories | Contents | 

Desc: This interrupt is generated when data is received from the keyboard. This is normally a scan code (from either a keypress *or* a key release), but may also be an ACK or NAK of a command on AT-class keyboards.
Notes: This IRQ may be masked by setting bit 1 on I/O port 21h. If the BIOS supports an enhanced (101/102-key) keyboard, it calls INT 15/AH=4Fh after reading the scan code (see #00006) from the keyboard and before further processing; all further processing uses the scan code returned from INT 15/AH=4Fh. The default interrupt handler is at F000h:E987h in 100%-compatible BIOSes. The interrupt handler performs the following actions for certain special keystrokes: Ctrl-Break clear keyboard buffer, place word 0000h in buffer, invoke INT 1B, and set flag at 0040h:0071h SysReq invoke INT 15/AH=85h (SysReq is often labeled SysRq) Ctrl-Numlock place system in a tight wait loop until next INT 09 Ctrl-Alt-Del jump to BIOS startup code (either F000h:FFF0h or the destination of the jump at that address) Shift-PrtSc invoke INT 05 Ctrl-Alt-Plus (HP Vectra) enable keyclick Ctrl-Alt-Plus (many clones) set clock speed to high Ctrl-Alt-Minus (HP Vectra) reduce keyclick volume Ctrl-Alt-Minus (many clones) set clock speed to low Ctrl-Alt-SysReq (HP Vectra) generate hard reset Ctrl-Alt-S (many clones) run BIOS setup program Ctrl-Alt-Esc (many clones) run BIOS setup program Ctrl-Alt-Ins (many clones) run BIOS setup program Ctrl-Alt-LeftShift-GrayMinus (some clones) turn off system cache Ctrl-Alt-LeftShift-GrayPlus (some clones) turn on system cache. DR DOS hooks this interrupt to control the cursor shape (underscore/ half block) for overwrite/insert mode. DR Multiuser DOS hooks this interrupt for cursor shape control and to control whether Ctrl-Alt-Del reboots the current session or the entire system
See Also:
INT 05"PRINT SCREEN" - INT 0B"HP 95LX" - INT 15/AH=4Fh - See Also:
INT 16/AH=00h - INT 16/AH=10h - INT 1B - INT 2F
 See Also:
INT 51"DESQview" - INT 59"DoubleDOS" - INT 79"GO32"
 
(Table 00006)
Values for keyboard make/break (scan) code:
01h    Esc              31h    N
02h    1 !              32h    M
03h    2 @              33h    , <              63h    F16
04h    3 #              34h    . >              64h    F17
05h    4 $              35h    / ?              65h    F18
06h    5 %              36h    Right Shift      66h    F19
07h    6 ^              37h    Grey*            67h    F20
08h    7 &              38h    Alt              68h    F21 (Fn) [*]
09h    8 *              39h    SpaceBar         69h    F22
0Ah    9 (              3Ah    CapsLock         6Ah    F23
0Bh    0 )              3Bh    F1               6Bh    F24
0Ch    - _              3Ch    F2               6Ch    --
0Dh    = +              3Dh    F3               6Dh    EraseEOF
0Eh    Backspace        3Eh    F4
0Fh    Tab              3Fh    F5               6Fh    Copy/Play
10h    Q                40h    F6
11h    W                41h    F7
12h    E                42h    F8               72h    CrSel
13h    R                43h    F9               73h     27h    ; : Notes:
Scan codes 56h-E1h are only available on the extended (101/102-key)
keyboard and Host Connected (122-key) keyboard; scan codes 5Bh-5Dh
are only available on the 122-key keyboard and the Microsoft Natural
Keyboard; scan codes 5Eh-76h are only available on the 122-key
keyboard.
In the default configuration, break codes are the make scan codes with
the high bit set; make codes 60h,61h,70h, etc. are not available
because the corresponding break codes conflict with prefix codes
(code 2Ah is available because the self-test result code AAh is only
sent on keyboard initialization).  An alternate keyboard
configuration can be enabled on AT and later systems with enhanced
keyboards, in which break codes are the same as make codes, but
prefixed with an F0h scan code.
Prefix code E0h indicates that the following make/break code is for a
"gray" duplicate to a key which existed on the original PC keyboard;
prefix code E1h indicates that the following make code has no
corresponding break code (currently only the Pause key generates no
break code).
The Microsoft Natural Keyboard sends make codes 5Bh, 5Ch, and 5Dh
(all with an E0h prefix) for the Left Windows, Right Windows, and
Menu keys on the bottom row.
The European "Cherry G81-3000 SAx/04" keyboard contains contacts for
four additional keys, which can be made available by a user
modification; the three new keys located directly below the cursor
pad's Delete, End, and PgDn keys send make codes 66h-68h (F19-F21);
the fourth new key, named  See Also:
#00602 at INT 16/AX=6F07h - #03214 at INT 4A/AH=05h
 
Category: 
Hardware
- 
Int 09h
- 
I
 
 
 
 
 
57h    F11              AAh    self-test complete
28h    ' "              58h    F12              E0h    prefix code
29h    ` ~              59h    [Note1] F15      E1h    prefix code
2Ah    Left Shift       5Ah    PA1              EEh    ECHO
2Bh    \ |              5Bh    F13 (LWin)       F0h    prefix code (key break)
2Ch    Z                5Ch    F14 (RWin)       FAh    ACK
2Dh    X                5Dh    F15 (Menu)       FCh    diag failure (MF-kbd)
2Eh    C                                        FDh    diag failure (AT-kbd)
2Fh    V                                        FEh    RESEND
30h    B                                        FFh    kbd error/buffer full

  
 
 
Interrups 
Categories 
Contents 
 
  
Shopping
  
Forum
  
EMail
  
Index
  
Home
 